First, the sealing process of the sealing machine
1. Use 220V single-phase three-wire power supply, grounding must be reliable, otherwise it will affect personal safety.
2. The metal parts cannot be close to the sensor head.
3. Check the cooling water level frequently. When it is used frequently, check it once a week and replenish the cooling water. It is best to use non-conductive cooling water.
4, often check the pipeline, the joints can not have water leakage, water seepage. In order to prevent the pipe from freezing due to low temperature, antifreeze should be injected into the water tank.
5, maintenance should follow the order of operation.
6, maintenance should be fixed professionals.
7. Do not open the chassis after booting. The total power must be cut off when checking maintenance.
8. The machine is designed with overload and overheat protection system. When the temperature of the heat sink exceeds 70 degrees, the high voltage will be cut off, and the warning light will flash: when the load is too large (that is, the heated cap is too large or closely arranged or too close to the induction head), the high voltage current of the machine is instantaneously overloaded (digital display) It can also be protected by instantaneously exceeding "100"). This is normal and can be initiated by pressing the "START" button again.
Second, the cleaning and maintenance of the sealing machine
1. Regularly clean the surface of the machine, the bottom plate and the lower die slide, the groove, the upper mold inner pressure plate and the positioning rod (Note: the power must be turned off and the normal temperature is restored).
2. Regularly add butter to the drive parts of the lower die slide, the pressure bar bearing, the eccentric wheel, the guide post, the guide rail, etc. to ensure the usability of the machine.
3, cleaning the knife method: first use the cotton ball to plug the two drain holes of the lower mold, pour the boiling water into the groove of the lower mold, fill it up, then push the lower mold slide into place, press the upper mold Press to the lowest point and let the tooth knife soak for a few minutes until it is clean, repeated several times.