1. When the ambient temperature drops below O °C, there is the possibility of icing. Drainage must be carried out to release the water. Otherwise, the inlet pipe may be broken!
2. When the ice machine is not in use, it should be cleaned, and the ice mold and the moisture in the box should be dried with a hair dryer, placed in a place free of corrosive gas and ventilated and dry, avoiding open storage.
3, the surrounding environment of the ice machine should be cleaned regularly, can not pile up debris, hinder heat dissipation.
4, the ice machine should be installed away from the heat source, no direct sunlight, good ventilation, the ambient temperature should not exceed 35 ° C, to prevent the ambient temperature is too high, resulting in poor heat dissipation of the condenser, affecting the ice making effect. The floor of the ice machine should be solid and flat, and the ice machine must be level. Otherwise, it will cause no ice and noise during operation. The ice machine is installed and used.
5. The gap between the back and left and right sides of the ice making machine should be no less than 30cm, and the top gap should be no less than 60cm.
6. The ice machine should be installed on a solid ground. The machine should be installed horizontally without tilting. Otherwise, the machine will vibrate when running, and if it is too large, it will save the water in the refrigerator and affect the quality of the ice.
7. The water pipes, sinks, storage refrigerators and protective film of the ice machine should be cleaned every two months.
8. The ice machine should use independent power supply, special line power supply and equipped with fuse and leakage protection switch, and it should be grounded reliably.
9. The water of the ice machine should meet the national drinking water standard, and a water filtration device should be installed to filter the impurities in the water to avoid blocking the water pipe and polluting the water tank and the ice mold. And affect the performance of ice making.
10. When cleaning the ice machine, turn off the power supply. Do not use the water pipe to directly align with the body. Use a neutral detergent to scrub. Do not use acidic or alkaline solvents to clean.
11. The ice machine must unscrew the inlet hose head for two months to clean the inlet valve screen to prevent the sand sludge impurities from clogging the water inlet, which causes the water intake to become smaller, resulting in no ice.
12. The ice machine must clean the surface of the condenser every two months. If the condensation is poor, the compressor components will be damaged. When cleaning, use a vacuum cleaner, a small brush, etc. to clean the condensed surface oil dust. Do not use a sharp metal tool to clean it to avoid damaging the condenser.
Zhejiang Shanying Trading Co.,Ltd. , https://www.shanyingtrading.com