Features of the belt filter press (dehydration) machine:
1. The sludge goes in and out:
The domestic filter press structure is that the sludge enters the filter press from the upper part of the filter press, passes through the slag-cylinder, and finally the mud is discharged from the lower part of the filter press, so that the sludge that has been dried is wetted by the water overflowing from the water tray. The sludge does not reach the pressure, which affects the use of the filter press. Jincheng filter press overcomes the above shortcomings, and adopts sludge to move in and out, which avoids the sludge that has been dried by the sludge and is wetted by the water overflowing from the water tray, which greatly improves the use effect of the filter press.
2, the whole machine uses 304 high-quality stainless steel, one-time investment, long-term use.
Because the belt filter presses are installed in places with serious environmental pollution, the acidity and alkalinity are relatively large. Although the ordinary carbon steel materials are treated with anti-corrosion treatment, they can not withstand the influence of harsh environment. After a while, they will be born. Rust greatly shortens the life of the machine. The Jincheng filter press adopts 304 high-quality stainless steel material, which overcomes the above shortcomings. It is durable and never rusts, and the machine is beautiful and elegant, which greatly reduces maintenance troubles and complies with environmental protection requirements.
3. An octagonal stirring dewatering cage device:
The device is mainly suitable for the material pre-dewatering system of the belt type filter press (dewatering) machine. The structure principle is based on the shortcomings found in the actual use process, and the key consideration is that the material has a high water content before being pressed into the filter chamber. The material is passed through an octagonal mixing dewatering cage to reduce the moisture content of the material by more than 50% and the volume of the material by about half. Therefore, the amount of material that enters the filter belt can be doubled, and the speed of the filter belt can be increased accordingly, which increases the amount of sludge from the filter press. The utility model adopts the utility model technology, and the conventional belt type filter press (dehydration) machine has more than double the efficiency of the same filter belt width, and also saves energy consumption and reduces equipment cost.
4, a belt filter press (dehydration) machine anti-corrosion shaft, sleeve transmission structure:
The structure is based on the shortcomings found in the actual use process, focusing on the anti-corrosion material selection of the transmission part, the entire structure completely solves the problem of corrosion, the transmission shaft is made of high-quality stainless steel material, and the sleeve is made of PTFE material. The shafts and bushings made of two materials will never rust. The wear coefficient is small at slow speeds and extends the service life. There is no mechanical rotation of the collision sound, and in the slow running, no noise is generated, which complies with the requirements of environmental protection.
5. A single-acting rubber wheel drive mechanism:
It can be seen from the structure and use principle of the utility model that the main roller and the driven roller do not have the same diameter, and the linear speed of the operation depends on the active rubber wheel, which is actually synchronous operation, and also acts as a belt pressure. The effect of filtration (dehydration) eliminates the need for sprocket and chain to reduce materials and spare parts. The overall structure is simple, installation and maintenance are very convenient, and the service life of the whole machine is extended. The noise generated by the machine is extremely small. , in line with environmental requirements. Avoid the difference in the diameter of the two rubber wheels, the filter belt will fold, shorten the life of the filter belt.
6, the machine is neat and beautiful, in line with environmental requirements:
The two sides of the rack are completely enclosed by ABS board, which is to prevent sludge and sewage from splashing out and pollute the environment, and the whole set of machines is neat and beautiful, and meets environmental protection requirements.