First, high speed centrifuge operating procedures
1. The table of the desktop high-speed centrifuge should be flat and sturdy, the work room should be neat and clean, dry and well ventilated.
2. Turn on the power switch and the indicator light will be on.
3. Turn off the power switch.
4. Open the centrifuge cover and wipe the inner cavity and rotor.
5. Load a test tube with the same weighing.
6. Close the centrifuge cap.
7. Set timing
8. Turn on the power switch
9. Adjust the speed control knob to the desired speed.
10. Before each stop. The speed control knob must be placed in the minimum position. The timer is set to zero. Turn off the power switch again.
11. Wipe the inner cavity and turn the head. Close the centrifuge cap.
Second, high-speed centrifuge maintenance 1. Do not place any material on the centrifuge cover, every time you use it, be sure to clean the inner cavity and rotor.
2. If the desktop high-speed centrifuge is not used for a long time, the centrifuge cover should be opened for a period of time before use to dry the inner cavity.
3. After the motor's carbon brush is used for 3,000 hours, it should be replaced in time to avoid wearing the commutator.
4. When the desktop high-speed centrifuge is used for a long time, the wear is normal.